abraded

英 [əˈbreɪdɪd]

美 [əˈbreɪdɪd]

v.  磨损(岩石等); 擦伤(皮肤等)
abrade的过去分词和过去式

过去分词：abraded　

COCA.44011

柯林斯词典

• VERB 磨损；磨蚀；擦伤
  Toabradesomething means to scrape or wear down its surface by rubbing it.
  1. My skin was abraded and very tender.
     我擦破皮了，一碰就疼。

双语例句

• It is occasionally applied to abraded surfaces with good results, especially if there is some rusting due to a delay in painting after blasting.
  这种方式常常被使用在磨擦过的金属表面，特别是那些在喷沙后因没有及时油漆而产生锈蚀的金属表面，并产生非常好的效果。
• Aircraft engines and helicopter Rotor-Blades are constantly abraded by atmospheric dust, and a way of slowing down this abrasion would be welcome.
  飞机引擎和直升机的螺旋桨叶会不停地被空气中的沙尘磨损，减慢这种磨损的方法会大有用武之地。
• After one set of teeth is abraded, the tooth-plate can be reversed so that the other set of teeth can be used, and therefore, the service life of the tooth-plate is increased.
  当一组牙齿磨损后，可掉过头来使用另一组牙齿，从而提高了牙板的使用寿命。
• It provides a reference for selecting method of repairing abraded shafts.
  这为磨损轴类零件的修复方法的选用提供了借鉴意义。
• The pen head of the xyloid handwriting pen for screen pen can be changed after being abraded, is convenient for the user to use, and avoids wasting;
  本实用新型所述的屏幕输入用木质手写笔的笔头可以在磨损后进行更换，方便用户使用，避免浪费；
• Whether difficult or easy the passive films were abraded depended on the properties of the films, the polishing pressures and rotational velocities.
  钝化膜的磨损难易程度与钝化膜的本身特性、抛光压力及转速有关。
• The freshly abraded specimen must then be washed in industrial spirit and Analar acetone.
  然后，研磨好的新鲜试样必须在工业酒精及纯丙酮中洗涤。
• Secondly, Classified inorganic materials have been crushed and abraded to make a lot of powder and store them separately.
  第二步，将分类后的原料按一定的设计要求进行粉碎与研磨并分门别类加以储存。
• To meet the requirements of new assembly procedures of wheel sets, the wheel tyre retaining ring roller mills for locomotives were developed. Third, tread and wheel rim will be abraded.
  为适应轮对新的组装工艺要求，研制了机车轮箍扣环滚压机。恢复踏面和轮缘的线型时，需要对车轮进行车削修整，导致轮箍与轮缘变薄。
• When the upright cutter blades are abraded and shortened, the upright cutter blades can be justified again through distance adjusting clamp holes for improving efficiency.
  当立刀片磨短后，通过调距卡孔有两次调齐，以提高效率。