就爱字典>英语词典>asperities翻译和用法

asperities

英 [æsˈpɛrɪtiz]

美 [əˈspɛrɪtiz]

n.  (尤指语言、态度)粗暴,严厉
asperity的复数

双语例句

  • The experiments indicated that asperities of roll surface plow and stick to the aluminum strip surface, and lubrication oil film in deformation zone shields surface topography of aluminum strip are the primary reasons of surface damage of cold rolled aluminum strip.
    实验发现:轧辊表面微凸体对铝板表面的犁削与粘结作用,以及变形区内润滑油膜对铝板表面形貌的屏蔽作用是冷轧铝板表面损伤的主要原因。
  • Influences of the cavitations between the asperities on roughness surfaces on flow factors were investigated.
    研究了粗糙表面上微凸体间气穴对用于混合润滑分析的流量因子的影响。
  • Load Capacity of Asperities for Piston Ring-Cylinder Liner in Internal Combustion Engine at Running-in Stage
    内燃机缸套-活塞环磨合过程中微凸体承载研究
  • However, at higher angle of tooth-shaped asperities and under higher normal stress, the failure model II is found, which is in first tension but final shear failure.
    在较高的法向应力下,含起伏角较高齿形节理面的非贯通节理岩体可能出现破坏模式II(先张拉后剪切破坏模式)。
  • The preparation and nucleation of a strong earthquake involve fracturing of asperities on the fault plane, and the foreshock activity, the dynamic rupture process and the precursors of the strong earthquake depend on the scale, the strength and the number of asperities.
    强震孕育过程中包含着凹凸体的破裂,断层面上凹凸体的尺度、强度及数量决定着前震活动的特征、强震动态破裂过程以及前兆现象。
  • Effects of barriers and asperities on seismic moment
    障碍体和凹凸体对地震矩的影响
  • If the gouge layer is thin, contact between asperities on the rock surfaces can occur.
    如果充填物层很薄,两个岩石表面上的凸起物就有可能互相接触。
  • The relationship between sliding friction force and contacting condition of rough surfaces was developed according to kinematics and dynamics analysis of two contacting asperities.
    从一对微凸体的接触力学和运动学分析出发,建立了非流体动力润滑条件下粗糙表面滑动摩擦阻力与粗糙表面接触状态间的关系。
  • Earthquake doublet in Kagoshima, Japan: rupture of asperities in a stress shadow
    日本鹿儿岛的地震对:应力影区中的凹凸体破裂
  • Based on the number of asperities on the fault plane, the asperity model was classified into three models: all-asperity, single-asperity and multi-asperity models.
    根据凹凸体的数量将凹凸体模型分为三种模型:所有凹凸体,单凹凸体和多凹凸体。