chamfer
英 [ˈtʃæmfə(r)]
美 [ˈtʃæmfər]
n. 斜切面; 削角
复数：chamfers 现在分词：chamfering 过去分词：chamfered 过去式：chamfered 第三人称单数：chamfers
COCA.44768
牛津词典
noun
- 斜切面；削角
a cut made along an edge or on a corner so that it slopes rather than being at 90˚
英英释义
noun
verb
双语例句
- The effects of rolling parameters such as plate width, roll contours, chamfer and straight chamfer parameters on the contact pressure distribution were studied.
研究结果表明，在轧制能力范围内，轧件越宽，轧辊采用凹辊型可以使辊身部的辊间压力分布更为均匀； - What is the nominal chamfer size?
什么是公称倒角尺寸？ - Also, the chamfer of the stay vanes entrance and the surface roughness of the flow channel were optimized by the numerical investigations.
亦对固定导叶入口冲角、涡壳壁面粗糙度对流动的影响进行了定量分析。 - Drag onto the page. Right-click to set chamfer angle.
拖到绘图页上。右击可设置切角角度。 - Based on physical simulation of edge rolling process in Trimming-Free Plate rolling method, the affection of V rolling and chamfer rolling on the plate profile is analyzed.
基于中厚板无切边轧制法中立轧轧边变形的物理模拟，分析了平辊立轧与倒棱轧制对中厚板断面形状的影响。 - After too large tooth resultant force is eliminated, tooth chamfer bone is OK proper motion rehabilitate, of the tooth become loose degree also return to normal subsequently;
当过大的牙合力消除后，牙槽骨可以自行修复，牙齿的松动度也随之恢复正常； - The Study and Realization of Auto Marking Chamfer and Taper in UG
倒角和锥度自动标注在UG中的研究和实现 - Marking chamfer and taper is a routine work in Mechanical drawing.
在机械制图中，通常需要进行大量的倒角和锥度的标注工作。 - Carefully remove smaller edges or burrs on the chamfer of the crankshaft flange with an oilstone if necessary.
如有必要，请用油石仔细去除曲轴法兰倒棱上的小边或毛刺。 - Fit the sealing ring at the correct position in the vacuum pump so that it is flush with the lower edge of the chamfer in the rotor.
将密封圈安装在真空泵的正确位置，以便密封圈与转子倒棱的下边缘平齐。