就爱字典>英语词典>deflections翻译和用法

deflections

英 [dɪˈflɛkʃənz]

n.  (尤指击中某物后)突然转向,偏斜,偏离
deflection的复数

柯林斯词典

  • N-VAR 偏斜;偏转
    Thedeflectionof something means making it change direction.
    1. ...the deflection of light as it passes through the slits in the grating.
      光线通过光栅狭缝时的偏转
  • (体育运动中球击中某物后的)转向,变向
    In sport, thedeflectionof a ball, kick, or shot is when the ball hits an object and then travels in a different direction.

    双语例句

    • The major application of these data is to define the control deflections required to stabilize the vehicle.
      这些数据的主要应用是确定稳定飞行器所需要的控制偏角。
    • Where required, to examine deflections, stiffness requirements, and any special material and design provisions to obviate brittle fracture under adverse conditions.
      必要时验算挠度、刚度要求、以及任一特殊材料和设计规定,以预防不利条件下的脆断。
    • The pace analyzes the current pre-arched calculation and installation method based on the relative deflections, and proposes a new absolute deflection method.
      本文在对现行的基于相对挠度的预拱度计算设置方法进行分析后,进而提出了新的绝对挠度法。
    • Experimental results indicate that the cracks weaken the strength of slabs, lower their stiffness, and induce the deflections of slabs beyond limit.
      试验结果表明,支座边的裂缝严重削弱了板的承载力,降低了楼板的刚度,导致楼板的挠度过大。
    • In this paper, a new method to measure meshing composite deflections of loaded cylindrical involute helical gear by using high precision clinometer is presented.
      提出利用高精度测角仪测量齿轮副在啮合过程中不同啮合位置时轮齿受载综合变形的新方法。
    • Analysis to Large Deflections of Elastic Cantilever Beam with Constraint under Uniformly Distributed Load
      均布载荷下变形受约束悬臂梁弹性大变形分析
    • The associated permitted deflections shall be included in the contract documents.
      相关许可挠度应当包含在合同文件中。
    • Equations are established based on the principle of deflections consistency.
      根据板簧变形协调原理,导出相应的方程。
    • The test results showed that the fracture deflections of the composite coatings and the fractal dimensions of the fractured surfaces decreased with increasing the contents of hard phases.
      测量了多相材料复合涂层的断裂挠度和断口表面的分形维数,分析了复合涂层的断裂特征结果表明:随着硬质相增加,复合涂层的断裂挠度和断口表面的分形维数降。
    • An increase in resistance to roll deflections may be gained by splitting the single strut into a fork at the top.
      采用上部分呈叉状的单支杆可以增强抗滚转变形性能。