elongations
英 [ˌiːlɒŋˈgeɪʃənz]
美 [ˌilɔŋˈgeɪʃənz]
n. 拔节; 拉长;伸长度;延伸率; 伸长(延伸)率
elongation的复数
双语例句
- The elongations of the leathers fatliquored by the sulfonated oil STO, sulfated castor oil and sulfated neatsfoot oil were better.
磺化油STO、硫酸化牛蹄油和硫酸化蓖麻油加脂的坯革伸长率较大。 - The results show that as the increase of the TDDM content, Izod impact strength first increase and then decrease, while the tensile strength and elongations of blends slightly decrease with the amount of TDDM.
结果表明:随TDDM含量的增加,共混物的冲击性能呈先增大后减小趋势。而拉伸强度,断裂伸长率降低。 - The yield strength ratio of hot dip galvanized dual phase steels will increase with increasing of leveling elongations. When the leveling elongation of steel is over 1.0%, its yield strength ratio is beyond the standard 0.61 requirement.
随平整伸长率增加,热镀锌双相钢屈强比增加,当平整伸长率大于1.0%时,钢的屈强比超过标准0.61的要求。 - It is found that the yield stress, the fracture strength and the micro-hardness of Mo-3 Nb single crystal materials by Russian supplying were higher than those of the home-made ones, while the elongations of the former material were lower than the later material.
结果表明:俄罗斯Mo-3Nb单晶屈服强度、抗拉强度、显微硬度比国产Mo-3Nb单晶要高,而延伸率略低; - The compliance of brachial artery at different elongations ( from 100%~ 140% of natural length) invitro was calculated on the basis of measurement of pressure-volume relationship in brachial artery of young men who died from accident.
通过对人的离体肱动脉全压力范围内压力(P)&容积(V)关系的测定,计算了血管自原位长(100%)及拉伸至140%间各阶段之顺应性(C)。 - The elongations at break and impact strength kept increasing with increasing content of PDMS.
冲击强度及断裂伸长率则随PDMS含量的增加而增加。 - Most of the specimens show distinct elongations of components.
多数标本的组份呈显著的拉长现象。 - Space Charge in EPR Insulator in Different Elongations Experiment Analysis for Tension and Destruction of Fiber Reinforced Rubber Composites
不同拉伸率的乙丙橡胶中空间电荷分布的研究纤维增强橡胶复合材料拉伸与破坏的试验分析 - Changes of Compliance and Morphology of Human Brachial Artery at Different Elongations and Their Clinical Significance
不同拉伸状态下人肱动脉顺应性与形态学的变化及其临床意义 - Using scaling tension test method simulated the effect of leveling elongations on yield strength ratio of hot dip galvanized dual phase steels.
研究了氮含量对热镀锌双相钢拉伸性能的影响,用定拉伸试验方法模拟了平整伸长率对热镀锌双相钢屈强比的影响。