tangency
英
美
网络 切线连续; 接触; 相切; 切向参考; 切矢连续
复数：tangencies
英英释义
noun
- (electronics) a junction where things (as two electrical conductors) touch or are in physical contact
- they forget to solder the contacts
- the state of being tangent
双语例句
- Their point of tangency is called the pitch point, and since it lies on the line of centers, it is the only point at which the tooth profiles have pure rolling contact.
大小齿轮的接触点称为节点，由于节点位于中心线上，因此节点是齿形轮廓线上唯一做纯滚动接触的点。 - The tangency portfolio is the portfolio that one should hold.
切点投资组合就是我们应该持有的投资组合。 - So now the urgent problem for us is to seek the point of tangency and point of balance for Intellectual Property law system which provide protection with Business Method and the perfecting of censoring standard and method of substantial requirements of Business Method patent.
因此，寻找现有知识产权法律制度对商业方法保护的切入点和平衡点，完善商业方法专利实质性条件的标准和审查方法，是我们当前迫切需要解决的问题。 - According to certain rules, points of tangency or intersection with obstacle area are selected as the key points to cell decomposition by sweeping the target area with a tangent that shifts length timely.
变长切线法通过切线扫掠目标区域，按一定规则选取由切线与障碍区产生的切点或交点作为关键点来进行单元分解。 - Then finally, the final step is to find what is the tangency line that goes through the riskless rate.
在最后，最终的步骤是找出一条，穿过无风险收益率的切线。 - Then everyone should be holding the tangency portfolio.
所有人都应该持有切线投资组合。 - Now, he's using a much longer sample than I did, so he's not going to get this tangency portfolio that I did.
他的样本跨度比我的要大多了，所以他得出的切线资产组合会和我的不同。 - Emergency Solution to the Equipment Failure of Subnet Access Node in Tangency SDH Loop
相切组网SDH子网接入点失效的应急方案 - The essence of arc joining is making the tangency of the arc and line or the arc and arc. The programmed Drawing method of arc joining based on AutoCAD secondary-development is studied in this article. The Visual LISP drawing program of arc joining is merited.
圆弧连接的本质就是使圆弧与直线或圆弧与圆弧相切，在此研究了基于AutoCAD二次开发的圆弧连接程序化绘制方法，用VISUALLISP语言编程建立了圆弧连接通用绘图程序。 - This paper studied the case that there is a known point of tangency of a circle and a parabola while the center of the circle is on the recession of the parabola.
应用数形结合的方法，研究了已知圆与抛物线有一个切点，而圆心在切点处抛物线的凹向的情形。