就爱字典>英语词典>yawing翻译和用法

yawing

英 [ˈjɔːɪŋ]

美 [ˈjɔːɪŋ]

v.  偏航
yaw的现在分词

现在分词:yawing 

柯林斯词典

  • VERB (飞机或船)偏航,偏离航线
    If an aircraft or a shipyaws, it turns to one side so that it changes the direction in which it is moving.
    1. As the plane climbed to 370 feet, it started yawing...
      飞机攀升到370英尺时,开始偏航。
    2. He spun the steering-wheel so that we yawed from side to side.
      他急速打着舵轮,把我们搞得摇来晃去的。

双语例句

  • The variation tendencies of the side force, rolling moment and yawing moment of the overtaking cars by two spaces are different apparently.
    超车车辆受到的侧向力、侧倾力矩和横摆力矩在两种间距下的变化趋势有着明显差别。
  • According to multivariable frequency design theory, this paper studies the coupling between a guided bombs yawing and rolling channels by relative gain.
    文中从制导炸弹的侧向扰动运动方程出发,根据多变量频率设计理论,用相对增益法,研究了制导炸弹航向和滚转通道的交联耦合。
  • They were subject to violent yawing at low wind speeds.
    它们在低风速下会发生强烈的偏离。
  • The yawing can apparently attenuate the angular displacement of both the tail and the attack angle of tail fin.
    艏摇的存在会明显的衰减尾柄主臂和尾鳍攻角的角位移。
  • Firstly, we apply a method of classical gain scheduling to design attitude stable system of three channels including pitching, yawing, rolling.
    首先,采用古典的增益调度方法分别设计俯仰、偏航和滚转三个通道的姿态稳定系统和自动驾驶仪。
  • In order to reveal the cause and mechanism of the vibrations, a torsional vibration model of tower was set up based on the structure and principle of the yawing system.
    根据风力机偏航系统的结构和偏航原理,建立塔架扭转振动的模型。
  • In each mode, it includes four attitude controls: rolling, pitching, yawing and thrust.
    在各种飞行模式下包含有四种姿态控制:滚动、俯仰、偏航和升降。
  • Analysis the components of yawing system, and the process of a circular route of oil.
    对于偏航系统,分析了偏航系统的组成,液压控制偏航系统的油液循环路线的过程。
  • Yawing moment of inertia of sprung mass
    簧上质量横摆惯性矩
  • Thirdly, by neglecting the coupling influence, the control laws of pitching, yawing and sloping movements are designed separately with frequency domain analysis and root locus, and then the parameters of the controller are chosen.
    第三,忽略耦合影响,将控制系统分为俯仰、偏航、倾斜三个相互独立的通道,用频域分析法和根轨迹法设计控制律、选取控制器参数。